+34 942 250 746nocu@nocu.esISO 9001:2015 certified
Resin foundry pattern on a plate in the Nocu workshop

Pattern or mould?

A one-and-a-half-minute animation that explains the difference between a foundry pattern and a mould: what each one is, who makes it and how many times it is used.

Request a quote
Video · 1:25

Voice-over: synthetic voice joe (Piper).

Video transcript

What is the pattern?

It is a replica of the casting, slightly larger to allow for metal shrinkage. It is made by the patternmaker, in wood, resin or polystyrene.

What is the mould?

It is the cavity with the shape of the casting, made in sand. The foundry makes it with the pattern, and the metal is poured into it.

How many times is each one used?

The pattern is reused to make many moulds, except lost patterns. The sand mould is broken to take out each casting.

And what about wooden moulds for casting?

In fact, what is made in wood is the pattern. The foundry uses it to make the sand mould, and the metal casting comes out of the mould.

Summary

The pattern is the replica of the casting: it is made by the patternmaker and it is reused. The mould is the cavity in the sand: it is made by the foundry and it is broken for each casting. The pattern makes the mould, and the mould makes the casting.

Need a foundry pattern?

Send us the drawing or 3D file and we will reply with a proposal.

Request a quotenocu@nocu.es+34 942 250 746

Shall we talk about your next project?

Send us the drawing or 3D file. Our engineering department will assess the part and propose the most suitable technology.

+34 942 250 746nocu@nocu.esPolígono Industrial de Morero, Parcela 1.6
39611 Guarnizo (El Astillero), Cantabria, Spain

The Google map only loads if you accept it, because Google Maps sets cookies.