Types of foundry patterns
A 3-minute animation that uses a combination spanner to explain six ways of making a pattern for sand moulding.
Voice-over: synthetic voice joe (Piper).
Video transcript
What is a one-piece pattern?
It is a pattern made in a single piece, with the full shape of the casting. It is moulded entirely in one of the flasks.
And a split pattern?
It is a pattern divided into two halves along the parting line. Each half leaves its impression in one flask.
What are pattern plates?
Each half of the pattern is mounted on its own plate: one for the drag and one for the cope.
And a pattern with a built-in wooden flask?
It needs no metal flask: the pattern is mounted on wooden boards with a wooden flask built in.
What is a buried lost pattern?
It is an EPS (expanded polystyrene) pattern that stays buried in the sand. When pouring, the metal vaporises it and takes its place.
And the breakable lost pattern?
It is also made of EPS, but the mould is made around it. Before pouring, it is broken and removed from the mould in pieces.
Summary
Six types of pattern for sand moulding.
Need a foundry pattern?
Send us the drawing or 3D file and we will reply with a proposal.
Shall we talk about your next project?
Send us the drawing or 3D file. Our engineering department will assess the part and propose the most suitable technology.
39611 Guarnizo (El Astillero), Cantabria, Spain
The Google map only loads if you accept it, because Google Maps sets cookies.
